10Micron Baader OMS-Nano Remote Switch The Baader OMS-Nano V2 is a network-operated remote switch for 10Micron mounts with Control Box V1/QCI or V2. It actuates the mount’s external on/off-switch input so an observatory operator can start or shut down the mount remotely.
Manufacturer model: 10Micron Baader OMS-Nano Remote Switch · Specifications checked against manufacturer data on 2026-11-04
The Baader OMS-Nano V2 is a network-operated remote switch for 10Micron mounts with Control Box V1/QCI or V2. It actuates the mount’s external on/off-switch input so an observatory operator can start or shut down the mount remotely.
Network operation
The module joins the local LAN and is accessed through its assigned IP address using a web browser. It is preconfigured for the supported 10Micron arrangement.
Switch behaviour and controller version
The OMS-Nano sends a momentary signal for a few seconds rather than maintaining a permanent connection. The maker describes the EXT SWITCH jack contacts as parallel to the mount’s front rocker switch. This 2455031 V2 product must not be confused with the separate 2455032 OMS-Nano V3.
Supplied equipment
The manufacturer lists a 12 V power adapter, 1 m mount connection cable, 3 m LAN cable, 2 m USB cable and instructions. Published net weight is 0.21 kg. It is a remote switch interface, not a multi-outlet power-distribution controller.
Exact Baader 2455031 / OMS-Nano V2 identified. Supports V1/QCI and V2, rather than the separate V3 product. The momentary external-switch connection must not be represented as a permanent supply relay.
Additional specifications
Model version
OMS-Nano V2
Compatible control boxes
10Micron V1 (QCI) and V2; not the V3 version
Network interface
LAN/Ethernet; browser access by assigned IP
USB function
Network configuration and firmware updates
Switching behaviour
Momentary signal for a few seconds; not a permanent closed connection
Mount connection
Three-contact EXT SWITCH stereo jack; two front contacts in parallel with the rocker switch, without ground
Supply
Included 12 V power adapter
Mount connection cable length (m)
1
Lan cable length (m)
3
USB cable length (m)
2
Included equipment
OMS-Nano unit; power adapter; connection cable; LAN cable; USB cable; instructions
2455031
Data sheet
Manufacturer part number
2455031
Model
10Micron Baader OMS-Nano Remote Switch
Net weight (kg)
0.21
Purpose
Remote mount on/off-switch actuation
Specific References
MPN
2455031
Used this product? Share your experience with other astronomers.
Comments (0)
No customer reviews for the moment.
Your review appreciation cannot be sent
Report comment
Are you sure that you want to report this comment?
Report sent
Your report has been submitted and will be considered by a moderator.
Your report cannot be sent
Write your review
Review sent
Your comment has been submitted and will be available once approved by a moderator.
10Micron Baader OMS-Nano Remote Switch The Baader OMS-Nano V2 is a network-operated remote switch for 10Micron mounts with Control Box V1/QCI or V2. It actuates the mount’s external on/off-switch input so an observatory operator can start or shut down the mount remotely.
Manufacturer model: 10Micron Baader OMS-Nano Remote Switch · Specifications checked against manufacturer data on 2026-11-04
